3 IN 1 PROSTHESIS: INSTRUCTIONS FOR USE

Instructions for use of Pymander 3 in 1 prostheses

PymTop ECO - REAL

PymBig ECO - REAL

ATTENTION

When shipped to you, the prosthesis may arrive with either talcum powder or silicone oil.

Just wash it with soap and water.

During daily use or after sexual intercourse, it should always be washed with soap and water and, depending on the reaction with your skin, you can use talcum powder (if too sticky), body oil (if too dry).

We cannot, a priori, know or establish how silicone will react with your skin, since each pH affects the organoleptic properties of silicone.

3 IN 1 ECO E REAL

PACK & STP FUNCTION

To wear the packer in everyday use, it is important to have boxers/briefs available

SLIM FIT, tight enough to keep the packer in place.

IMPORTANT: the packer must not come into direct contact with the lower part of the genitals, but must remain lying along the pubic area.

PLAY FUNCTION

To wear the packer during sexual intercourse, it is important to have SLIM FIT boxers/briefs, harnesses or boxers with an opening at the front.

PLEASE NOTE: the prosthesis cannot remain attached to the pubic area during sexual intercourse using medical glues, which are not a substitute for boxers or harnesses.

CLEANING AND LUBRICATION

To insert the rod into the prosthesis, ALWAYS use water-based lubricant, and during sexual intercourse.

It is essential to clean the packer after each use with warm water and neutral soap.

There is no need to purchase special “sex toy cleaning” products or sanitizers.

To maintain the quality of the prosthesis in the long term, we recommend always using water-based condoms. This will also protect you from sexually transmitted diseases and infections.

NOTE: INSERTION OF THE POLE FOR SEXUAL INTERCOURSE

In the new elongated shafts in production from February 2024, the testicles of the prosthesis remain partially empty.

CAUTION: To prevent tearing of the skin, hold the tip with your hand, NOT the skin, and lubricate the shaft well with water-based lubricant. DO NOT FORCE the insertion, the shaft should slide easily.